Performing the Power-On Self Test (POST) ------ UART Channel Loopback Test..PASS Testing the System SDRAM..PASS Boot1 Checksum Test..PASS Boot2 Checksum Test..PASS Flash Image Validation Test..PASS BOOT Software Version 1.0.0.03 Built 08-Jun-2004 09:48:10 CPU - FireFox 88E6218 ARM946E-S processor 64 MByte SDRAM. I-Cache 8 KB. D-Cache 8 KB. Cache Enabled. Autoboot in 2 seconds - press RETURN or Esc.
You can try disabling the input device with the xinput command. Egalax driver.
Otherwise, you can use existing ones, the proposed range is wide enough for a large number of common situations. The manual is quite clear, but the machine is quite complex, the effects of internal routing using virtual mixers we have to connect the desired chaining (serial, parallel, etc.) And for each of the effects modules.
To abort and enter prom. Preparing to decompress.
Decompressing SW from flash HOSTG_rscode_file_load: could not load file Perform WARM BOOT. When I go to the Hyperterminal an press 'Downloading from Xmodem' and select Send File. Select the firmware image (older FW) and choose Xmodem as the protocol, then I get an error:-( Is here anybody reactivated the switch from this loop with an older fw? Thankyou K.R. Just wanted to give an update for the users still using or have a SRW2016 or SRW2024 switch stuck in a loop. Since you cannot access the switch via telnet or http you must connect through the serial/console port and load an older rev of the firmware to get the switch out of the loop. It appears the older versions of boot code do not like the 1.2+ firmware.
The easiest way to get back normal operation of the switch is, as stated above. Load an older rev of the firmware through the serial port with Xmodem.
Once you have an operating switch, you can then load the newest rev of boot code, reboot, then load (through serial again) the latest 1.2+ firmware. There are already posts on here going through the step-by-step details of this process, but if you find yourself lost, email/msg me and I will help. Thanks -Adam. I had my SRW2024 stuck in a loop after upgrading to version 1.2.2. I was successfully able to downgrade back to 1.00.86 using the XMODEM method and breaking the loop after the POST.
I did not have access to a LinkSys cable. I first tried a serial cable, then a null modem cable and finally had to build a custom cable to connect to the console port. Pinouts are 1-1, 2-2, 3-3, 4-4, 5-5, 6-6, 7-7, 8-8 and 9-9. Each pin is straight through. Everything I have read indicates that I need to upgrade my boot code as well as the firmware. The problem is I cannot find where to download the latest boot code.
The LinkSys site redirects to Cisco when you search for the SRW2024. The Cisco site allows you to download 3 versions of the firmware, but I cannot find anywhere to download the boot code. Can anyone assist me by pointing me in the right direction or providing a url link to the latest boot code. OK I upgraded my srw2016 with out any problems and with out needing the console or telnet step one get the files runtop_boot-101.rfb and ls20xx-12230.ros runtop is hard to get Cisco removed it from the downloads damning you to fail but you can get it with the help of Google. Step two get a Tftp server I got TFTP32 but you can use just a bout any.